This headline doesn’t seem to match the article content at all. He never says that. He makes a statement about how people are interpreting AI as filling a “God shaped hole”, but that’s as close at it gets.

Hah, yea. 100% adding on 😀 Hopefully tomorrow is a brighter day!

Or open an editor?

It can. All standard spec NFC: https://specs.openprinttag.org/#/nfc_data_format

So any USB or GPIO reader would work. This will be in Klipper quick I bet.

alias diff='diff --width=$COLUMNS --suppress-common-lines --side-by-side --color=always'

Also, it’s loud by default. I immediately switched the two fans underneath for noctuas, which helper a ton. Now the only thing I hear is the loud “quacking” of the auxiliary feeder, for which there are software mods to silence that I just haven’t done yet.

I’ve been pretty happy with it. PLA is pretty spot on, and I need to scale ABS by 100.4% for large parts to cover shrinkage but I do that with other printers, too.

Is it as dimensionally accurate as the Voron V0.2 above it in that picture? No. But is it really close? Yes. If your tollerences are a mm, you’ll be fine. I’d only worry if the tolerences were less thsn say .2-.4 mm. Just remember some materials shrink as they cool, no matter what printer you use, so calibration is key for them.

Given you’re thinking chamber heater, you probably already know how to handle that, though.

OK, will so some test layers

And released at: https://nowsci.com/mods-for-3d-printers/

Thanks! Been doing CAD/printing for a long time focused on things like furniture supports/etc, too. So I’ve gotten pretty good at the “match”.

Thanks! It’s been there a while (minus riser) with no issues. Thats the corner of a bathroom, and it would be highly unnatural to be that close in-person. No kids is also key.

Also @toynbee@lemmy.world and @sepi@piefed.social

Also I misread two comments together and thought you mentioned the display panel. Soooo…

I don’t think so since there is no “squish”

Yea I’m beginning to wonder of flow rate isn’t adjusted for the brim. I may do a test as you can see through the gaps.

The layer looks “OK” after but you can see the lines more than normal. The biggest failures are ABS coming off the plate during the print.

Zoom.

Root system growing around and into another trunk. Two sticks as one, fused by nature. I say it counts.

Funny seeing this as the first thing in Top as I am missing my flight connection due to it. ¯_(ツ)_/¯

I thought that was a doorway to an incinerator in a mortuary and that this was a meme. I’ve been internetting too long.

The 2.0 release resolves a large amount of technical debt and shifts the focus toward compatibility and easier upgrades.

ZFS sending to a remotelab.

In your country.