Bambu lab a while ago came out with printers and an ecosystem that was very easy to use compared to other printers for the price. However, there were a few red flags like proprietary parts, software which required the cloud, and DRM chips in filament. Bambu lab promised they weren’t gonna exploit any of that and that they will keep their printers and ecosystem open and all the red flags were just used to aid in user experience like automatic print settings for DRM chipped filament, easy to swap parts, and cloud monitoring and notifications. Despite the promise, they’re still a corporation and thus went against their word and closed off 3rd party slicers and firmwares so you must use their cloud and their software.

You do not own the printers, Bambu does. So now you cannot install third party firmware on your Bambu 3d printer or use a different slicer. Everything you do on your Bambu printer goes through their cloud unless you take countermeasures and use old versions of software and firmware before the lockdown happened and you completely block internet access to the printers.

People saw these big red flags early on and called them out on it saying they’re gonna lock down their ecosystem later on but people kept buying into Bambulab since they were so easy to use and got amazing prints out of them.

Tl;Dr, Bambulab released printers and software that were so easy to use for the price but came with many red flags. Bambulab ended up closing down their entire ecosystem so they have full control of the printers and you are at their mercy if you wanna keep using it.

They might care if it’s 69420 since the max port number is 2^16 = 65536

I’ve a massive blob like this one time when the nozzle got clogged and the extruder created enough pressure to push the filament through the threads of the hotend block. It was on an Anet A8 and I ripped a lead off the thermistor trying to get the plastic off so I ended up replacing the entire hotend.

You can try to heat up the hotend to a fair bit under the melting point of the filament to where it’s soft and somewhat pliable but not runny or sticky and then trying to peel it off. Though you’d risk damaging any leads to the thermistor, heater, or your hands if you’re not careful.

Good luck on fixing the printer and getting back to printing again. 3D printing is a really time consuming hobby

There’s also the whole fact that you’re less likely to get downvoted and berated to hell on lemmy. Still happens sometimes though if you openly present as American