AppearanceBoring9229@sh.itjust.works to 3DPrinting@lemmy.worldEnglish · 10 days agobought a glass too small for my fridge so I fixed it 3d printingsh.itjust.worksimagemessage-square17fedilinkarrow-up146arrow-down10
arrow-up146arrow-down1imagebought a glass too small for my fridge so I fixed it 3d printingsh.itjust.worksAppearanceBoring9229@sh.itjust.works to 3DPrinting@lemmy.worldEnglish · 10 days agomessage-square17fedilink
minus-squaretechnomad@slrpnk.netlinkfedilinkEnglisharrow-up15·10 days agoHey, could you show us a bit more perhaps? It’s not very clear what you fixed exactly.
minus-squaremoody@lemmings.worldlinkfedilinkEnglisharrow-up9·10 days agoI think they meant a piece of glass. Looks like what would go on top of the cheese drawer in the fridge.
minus-squareAppearanceBoring9229@sh.itjust.worksOPlinkfedilinkEnglisharrow-up2·9 days agoHad to make a second version because the one on the post was too fragile. It was bending with just the glass. The new one looks like this
minus-squaretechnomad@slrpnk.netlinkfedilinkEnglisharrow-up2·9 days agoOh, nice fit! Are you pretty satisfied with it so far? I don’t imagine it would have any issues with the cold temps, and it pretty much looks like it came with the fridge. Good work!
minus-squareAppearanceBoring9229@sh.itjust.worksOPlinkfedilinkEnglisharrow-up2·9 days agoYes, it looks better than I expected. I will seal it later to prevent bacterial growth as someone suggested here
Hey, could you show us a bit more perhaps? It’s not very clear what you fixed exactly.
I think they meant a piece of glass. Looks like what would go on top of the cheese drawer in the fridge.
Had to make a second version because the one on the post was too fragile. It was bending with just the glass. The new one looks like this
Oh, nice fit! Are you pretty satisfied with it so far? I don’t imagine it would have any issues with the cold temps, and it pretty much looks like it came with the fridge. Good work!
Yes, it looks better than I expected. I will seal it later to prevent bacterial growth as someone suggested here