I tried switching to LAN, it took multiple attempts and half a day to get my mini to show up as a choice for LAN mode in Bambu Studio. And then when shut off for the night, it was gone again in the morning. As in it couldn’t be found. And now it’s back to Studio not connecting to it.
I’m not sure what I can do besides using the sneaker net to run it.
I’m going to save your comment for now. I have a script that I use at work that helps with printer detection because we have a very similar issue. I’ll try to post it here if I remember.
Running the script after launching Bambu studio helps with detection of the printer. Only caveat is that you have to run it every time you launch Bambu studio.
It’s nothing malicious, I’ll just post the code for you with the important bits that need to be changed noted.
I tried switching to LAN, it took multiple attempts and half a day to get my mini to show up as a choice for LAN mode in Bambu Studio. And then when shut off for the night, it was gone again in the morning. As in it couldn’t be found. And now it’s back to Studio not connecting to it.
I’m not sure what I can do besides using the sneaker net to run it.
I’m going to save your comment for now. I have a script that I use at work that helps with printer detection because we have a very similar issue. I’ll try to post it here if I remember.
Running the script after launching Bambu studio helps with detection of the printer. Only caveat is that you have to run it every time you launch Bambu studio.
It’s nothing malicious, I’ll just post the code for you with the important bits that need to be changed noted.