It’s 99% done. I cut the platform panels an inch too wide, so I’ll need to rip those down. That’s a PIA, because the only way I have to do that is to lay them out on the driveway on a sheet of foam insulation and cut it with the circular saw.
The Vevor pocket hole jig worked perfectly. It’s the first time I’ve used one. I picked the Vevor over the Kreg because the Vevor is made of machined aluminum instead of plastic and was also cheaper. Recommended.
If I were going to do it again I’d build it almost entirely out of plywood and hire someone with a big CNC router to cut the parts. I just didn’t think of it till after I started, even though I used a 5’ X 10’ Multicam CNC router at my last job. I only thought about how I could build it with the tools I had. Man, it would have been so much easier, would have come out nicer, and probably wouldn’t have cost too much more.
That “custom wood stand” is required by code for gas water heaters, and came with the house. It’s pretty damn sturdy. I think it’s about keeping the ignition source above gas vapors.
Yeah, that makes sense. It is a garage. Not as common in the north to put water heaters in garages. Carry on