I have a very short equipment rack installed in my server closet. It is only 16 inches deep, fine for most networking uses, but not great for most rack-mount server cases.
I am looking for case suggestions that would fit my rack, 16 inch depth maximum. Height isn’t a problem, the rack has a ton of vertical space, over 15U, it’s the depth that’s an issue.
Thanks!
You must log in or register to comment.
deleted by creator
Thanks for the link!
These guys do short depth PCs. I wish I knew where they got their cases from, because they are really nice!
But I haven’t found anything decent in the wild (I eventually gave up and got a deeper rack so I can use old r730 servers)Thanks for the link! Yeah, I’m starting to think I might just need to give up and get a deeper floor rack.
There are some good short chassis like the Silverstone RM-23-502-MINI, but the minimum length for the recommended rails is still 22 inches :(
I’ve not used them yet but was looking at https://www.plinkusa.net/
They have a variety of heights and depths, some of them being 15”
Great resource, I’ll check them out.
I recently hunted for a rack mounted case for an ATX MB and PSU. The best I could find is 17.9" deep. Is your rack’s rear end closed? Any way to remove the rear panel? There is a site that’ll make you a custom rack mount case I came across. But it was mighty pricey.
Back end is open but wall-mounted. If there is a way to mount the case forward a few inches so it leaves a gap in the back, that would be fine with me.
I haven’t found any brackets that seem to do that though.
How about mounting the rack a few inches off the wall?
Make your own brackets with construction lumber or plywood?
The 45Drives homelab case is 17.125" deep
Also an option I am considering. I prefer something a little more professional if possible, but not a bad option if I can’t get something else to work.
I’ll take a look at the 45 Drives case, thanks!
Chenbro makes quite a few ATX shallow rack mount cases. I have one and have no complaints.
I’ll check them, Ty!
https://www.amazon.com/gp/aw/d/B09227RQV2?psc=1&ref=ppx_pop_mob_b_asin_title
This is my favorite rack mount chassis I’ve worked with … and it coincidentally is in that ballpark.
Interesting design, I’ll look at it, thanks!
Sliger has a few rackmount chassis which are only 15 inches deep.
Oh nice, these might be exactly what I need, thanks!
